€1,299.00
€999.00
Incl. ... VAT (...),excl. Shipping Cost

Rega Planar 3 TAD 22 Anniversary Edition

Anniversary Edition with RB330 Tonearm, Rega Exact Cartridge and NEO PSU
0%Financing from just € 83.25 a month, with a 12-month term.
Delivery Time:
1-3 business days
In stock

If you have any questions about this article, just contact our customer service.

Info Hotline: +49 30 253 753 0

If you can not reach us by phone, just use our contact form:

22 Years of TAD and 14 Years of Cooperation with TAD and Rega Research.

? RB330 tonearm
? NEO PSU
? Exact pickup system pre-assembled
? EBLT drive belt
? Special color "Light Grey"
? Smoked cover with TAD anniversary logo
? Printed mat with TAD anniversary logo
? Black felt mat (100% wool) additional.
? Limited to 400 pieces!

Planar 3
Rega's proven top-of-the-line RP3 turntable has been reinvented and outgrows itself in the Planar 3 version.

Completely rebuilt, with so many improvements that one could almost speak of an RP4 here....

The only thing that has remained is the proven basis, the powerful engine - beyond that, basically everything has been optimized or redesigned. For example, the Planar 3 already has the new RB 330 tonearm - with a new bearing housing, improved anti-skating function and low-capacity internal wiring. In addition, the development of the Planar 3 was all about smoother running and greater stability.

Additional resonance-reducing measures were taken everywhere - not much, but in exactly the right places. The frame itself and the struts were efficiently reinforced, the brass housing for the bearing was worked even more precisely, and the new feet of the Planar 3 were also optimized for perfect energy dissipation. And then, with its new acrylic finish, the Planar 3 also looks quite a bit classier.

Exact MM cartridge system
Rega 3-point mounting & highest possible pickup efficiency for more dynamics, transparency & detail.

? Mounting weight 1.5 to 1.75 g
? Output voltage 6.8 - 7.2 mV
? Shorter, even more precise coil winding with even less mass.
? Diamond needle with "Vital" cut on a special, fixed mounted needle carrier
? Available color variant: yellow
? Weight: 6.5 g

NEO PSU MK2 power supply unit
It is thus a welcome addition to all Rega models with which it can be used,
these are P3-24 / RP3 / Planar 3 2016 / RP6 / P5 / P7 / RP40 special edition / RP8 and any older model equipped with our 24 volt motor conversion kit (except for Planar 1, Planar 2, P9).
The Neo uses a crystal stabilized digital signal processor like the one used in the Planar 10.
This DSP generates from the clock signal a sine wave with the exact frequency needed with the 24V drive to precisely maintain the platter speed.
An anti-vibration circuit, fine speed adjustment and electronic speed switching are among its main features.

? Quartz stabilized signal processor as for Planar 10 power supply.
? Generates perfect sinusoidal waveform for each speed
? Electronic speed switching
? Fine speed adjustment possible by hand on rear of unit
? Fine speed adjustment in steps of 0.01/min
? Anti-vibration circuitry

Harald Bialluch

We have a comprehensive selection of Rega turntables available for demonstration in our HiFi studios in Berlin-Kreuzberg. We look forward to your visit!

Your Rating
You're reviewing: Rega Planar 3 TAD 22 Anniversary Edition Please note that customer entries are published subject to moderation, therefore they may not be immediately visible.
Our Store In Berlin

Our Store In Berlin

HiFi im Hinterhof
Großbeerenstraße 65/66
10963 Berlin-Kreuzberg

+49 30 253 753 0
eshop@hifi-im-hinterhof.de

Opening Hours Mon - Fri: 12 p.m. - 7 p.m.
Sat: 10 a.m. - 3 p.m.

Directions

Opening Hours Mon - Fri: 12 p.m. - 7 p.m.
Sat: 10 a.m. - 3 p.m.
Saxman

We Keep Up With The Latest

Visit Our HiFi & Friends Blog Now