Goldring EROICA-H
If you have any questions about this article, just contact our customer service.
Info Hotline:
If you can not reach us by phone, just use our contact form:Goldring EROICA-H
Goldring, introduces the latest member of its moving coil cartridge family, the Eroica HX. Joining the award-winning LX model in the Eroica range (‘Eroica’ translates as ‘Heroic’ in Italian), this high output, high-performance cartridge makes upgrading from a moving magnet cartridge to a moving-coil model straightforward. It achieves this by delivering a stunning moving coil performance from a moving magnet input and is one of the most obvious and cost-effective upgrades you can make to your vinyl audio system.
Key features at a glance
- New, pure-iron cross-armature design for low crosstalk and reduced effective mass
- Ultra-fine, enamelled-copper windings for higher output and correct impedance matching
- Equipped with Gyger II diamond stylus that traces frequencies as high as 50kHz without distortion
- Housing made from lightweight Pocan® composite material, chosen for its anti-colouration properties
We have a comprehensive selection of Goldring devices available for demonstration in our HiFi studios in Berlin-Kreuzberg. We look forward to your visit!
Model | Eroica HX |
Frequency response ± 3dB | 20Hz - 20kHz |
Frequency Response | 10Hz - 50kHz |
Channel parity | within 1dB @ 1kHz |
Channel Separation | better than 25 dB @ 1 kHz |
Output Voltage | 2.5 mV ± 1dB, 1kHz @ 5cm/s |
Needle compliance | 25mm/N |
Scan capability | 85 µm (@ 315 Hz) |
Equivalent needle mass related to the scanning point | 0.4mg |
Vertical toe angle | 22° |
Needle grind | Gyger II |
Load Resistor | 47kΩ |
Capacitive Load | 100 - 500pF |
Coil inductance | 0.13mH |
Coil Impedance | 35Ω |
Weight | 5.2g |
Weight (including screws) | 6.6g |
Mounting screw spacing | 12.7mm (0.5") |
Following Force | 1.5 - 2.0 g (recommended: 1.75 g) |