Ortofon MC Cadenza Black
If you have any questions about this article, just contact our customer service.
Info Hotline:
If you can not reach us by phone, just use our contact form:Ortofon MC Cadenza Black
Cadenza Black is optimized for an amazing tonal neutrality, dynamics and purity of sound.
The Cadenza Black model is using a Nude Shibata stylus with a boron cantilever. The effective mass of the stylus/cantilever system is extremely low due to the use of a very thin boron rod. This material is extremely stiff and even more lightweight than aluminium.
It also uses the WRD/Wide Range Damping-system applied for MC Windfeld, MC A90, MC Anna, Xpression and MC A95 cartridges, controlling the high and low frequency damping separately.
The coil wire is the famous Ortofon Aucurum wire, which is a gold plated 6NX copper wire.
Cadenza Black is high performing on areas like detail, consistency and sound staging.
We have a comprehensive selection of Ortofon devices available for demonstration in our HiFi studios in Berlin-Kreuzberg. We look forward to your visit!
Model |
Ortofon MC Cadenza Black |
Pickup Type: |
MC (low output moving coil) |
Output Voltage: |
0.33mV* |
Amplifier connector: |
Phono MC |
Channel deviation at 1 kHz: |
<0.8dB |
Crosstalk attenuation at 1kHz: |
>27dB |
Crosstalk attenuation at 15kHz: |
>20dB |
Frequency range: |
20-60,000Hz |
Frequency Response: |
20-20,000Hz +1.5dB/-0Db |
Sampling capability at 315Hz: |
90m** |
Needle Give: |
16µm/mN |
recomm. Tonearm Type: |
moderate |
Scan Diamond: |
Shibata, naked |
Fillet: |
r/R 6/50µm |
Tracking force range: |
20-25mN (2.0-2.5g) |
recomm. Tracking Force: |
23mN (2.3g) |
Scan Angle: |
20 degrees |
DC Resistance: |
5 ohms |
recomm. Terminator: |
50-200 ohms |
Case material: |
Stainless steel/aluminium |
Height: |
18mm |
Weight: |
10.7g |
Special features: |
Aucurum*** winding, boron cantilever |
*at 1000Hz, 5cm/sec. **at recommended tracking force. ***Aucurum: Wire made of gold-plated, monocrystalline, oxygen-free 6N pure copper (OFC 99.9999%) |
|
|